Operation - EINHELL GE-CT 18 Li Traduction Du Mode D'emploi D'origine

5.6 Adjusting the additional handle (Fig. 11)
Undo the catch (Item 3) on the additional handle
until the handle can be moved forwards and
backwards without any great resistance. Set the
required position and tighten the securing screw
again.
5.7 Adjusting the angle of tilt of the long
handle (Fig. 12)
Press the button for the angle of tilt adjustment
(Item 14). Now you can set the long handle to
the required tilt. Release the button and allow the
handle to lock into position to fi x the angle of tilt.
Three diff erent locking angles are possible.
5.8. Installing the battery (Fig. 13/14)
Press the side pushlock button of the battery
pack as shown in Fig. 13 and push the battery
pack into the mount provided. When the battery
is positioned as in Fig. 14, make sure that the
pushlock button latches in place! To remove the
battery pack, proceed in reverse order.

6. Operation

6.1 Charging the Li battery pack
The corresponding instructions can be found
in the original operating instructions for your
charger.
6.2 Battery capacity indicator (Fig. 15)
Press the battery capacity indicator switch (16).
The battery capacity indicator (15) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs lit:
The battery is fully charged.
2 or 1 LED(s) lit:
The battery has an adequate remaining charge.
1 LED fl ashing:
The battery is empty, recharge the battery.
All LEDs fl ashing:
The battery pack has been deep-discharged and
is defective. Do not re-use or charge a defective
battery pack.
Anl_GE_CT_18_Li_Solo_SPK7_USA.indb 13 Anl_GE_CT_18_Li_Solo_SPK7_USA.indb 13
EN
To obtain maximum performance from your grass
trimmer, please follow these instructions:
•
Never use the grass trimmer without the
guard.
•
Do not mow grass when it is wet. The best
results are achieved with dry grass.
•
To switch on your grass trimmer, press the
safety lock-off (Fig. 2 / Item 1) and the On/Off
switch (Fig. 2 / Item 2).
•
To switch off your grass trimmer, let go of the
On/Off switch again (Fig. 2 / Item 2).
•
Do not allow the grass trimmer near the grass
until the switch is pressed, i.e. the grass
trimmer is in operation.
•
To cut properly, swing the machine sideways
while moving forwards. Keep the grass
trimmer inclined at an angle of approx. 30°
while you do so (see Figs. 16 and 17).
•
If the grass is long, the grass must be cut
shorter in stages, starting from the tip (see
Fig. 18).
•
Use the guard hood to prevent unnecessary
wear.
•
To avoid unnecessary wear, keep the grass
trimmer away from hard objects.
Using the grass trimmer as an edge trimmer
To cut the edges of lawns and fl ower beds, the
grass trimmer can be converted as follows:
•
Remove the battery pack
•
Pull the lock for the rotatable motor head in
the direction of the arrow as shown in Fig. 19.
•
Turn the motor head through 90° in the
required direction until it latches in place (Fig.
20).
•
Now you have converted the grass trimmer to
an edge trimmer for cutting the lawn vertically.
•
To convert the equipment back to its original
state, proceed in reverse order.
- 13 -
09.01.2019 10:04:57 09.01.2019 10:04:57