Overheating Alarm; Power Failure Alarm; Hopper Safety Alarm - Cadel MARTINA Manuel D'installation, Utilisation Et Maintenance

6.5. OVERHEATING ALARM

If the fumes probe reads a temperature above 200°C at the outlet point, "RiS" appears on the display
and the amount of fuel (pellets) is reduced at stage 1. The purpose of this function is to allow the values
to return to the preset figures. If for any reasons the temperature does not drop, but increases, at 215°C
"Hot temp" appears on the display. The circuit board keeps the fumes extractor on for 15 minutes for
the stove to cool. Reset the error pushing ON/OFF button. Check the type of fault, as shown on
After removing the cause of the fault, clean the burn pot and start the stove with the ON/OFF button.

6.6. POWER FAILURE ALARM

When the electricity returns after a black-out the stove display shows "AlAr no rEtE". The fumes
extractor will expel smoke residue for 20 minutes and start the turning off process. Reset the error
pushing ON/OFF button. When the stove is cool, check the type of fault, as shown on
removing the cause of the fault, clean the burn pot and start the stove with the ON/OFF button.

6.7. HOPPER SAFETY ALARM

There is a thermostat probe near the hopper, which cuts in if the temperature range of the hopper
exceeds the limits allowed, thereby eliminating the possibility for the pellets in the hopper to ignite due
to overheating. If the words "AlAr Sic" appear, the manual reset thermostat cuts out electricity to the
auger, stopping the supply of pellets to the burn pot and starting the turning off procedure. Reset the
error pushing ON/OFF button. Once the stove is cold, check the type of fault, as shown on
After removing the cause, reset the thermostat: loosen the black cap
– MANUAL RESET), press the little black button and replace the protective cap. Clean the burn pot and
restart the stove pressing ON/OFF button.
Pag. 80
(see Picture 15, page 90, Detail 6
MARTINA-SOLARIS-ALESSIA-VANESSA
page 87.
page 86. After
page 87.