Miele Complete C3 SG 2 Série Mode D'emploi page 48

en
The vacuum cleaner has symbols on
the controls which indicate the type of
use the settings are suitable for.
The setting selected will light up yellow.

Curtains, fabric

Upholstery, cushions

Cut pile carpets, rugs and run-
ners

Energy-saving vacuuming. This
setting is also very quiet

Loop pile carpet and rugs

Hard flooring and heavily soiled
carpets and rugs
When using the adjustable floorhead,
if the suction seems too high, reduce
the suction until the floorhead is
easier to manoeuvre.
Depending on the model, your vacuum
cleaner will be fitted as standard with
one of the following suction power se-
lectors:
– Foot controls
– Radio-control handle
Foot controls (dia. 23)
The first time the vacuum cleaner is
switched on, the highest setting will be
selected automatically.
After that the vacuum cleaner will
switch on at the setting which was used
previously.
 Press the + foot control to select a
higher setting.
 Press the - foot control to select a
lower setting.
48
Footswitch with Boost function
(dia. 24 + 25)
Some models also feature a Boost
power function. This function uses in-
creased power for a short period for va-
cuuming both fine and coarse stubborn
soiling.
 Press the + footswitch until the max-
imum power level has been reached.
 Then press the + footswitch again.
This activates the Boost function for 20
seconds. The Boost indicator will light
up yellow.
You now have the following options:
 Press the - footswitch before the 20
seconds have elapsed.
This switches the Boost function off
and activates maximum power.
 Press the + footswitch again once the
20 seconds have elapsed.
This activates the Boost function for an-
other 20 seconds. It can be activated
three times in a row. After that a pause
of one minute is required before reactiv-
ating it.
Using the Boost power setting
changes the actual power consump-
tion (see "Notes on Delegated Regu-
lation (EU) No. 665/2013 and
666/2013").
Radio-control handle (dia. 26)
When the vacuum cleaner is switched
on with the On/Off foot control , the
Standby indicator  on the vacuum
cleaner will light up yellow.