Laserworld Diode Série Mode D'emploi page 9

Manual: Diode Series
Channel
10
11
Please note that not each pattern can be combined with each effect.
• ILDA control:
Connect your device („ILDA IN") via an ILDA cable to an interface / controller. ILDA mode
starts immediately. Use a laser control software, e.g. Laserworld Showeditor, to run the
device. Use „ILDA OUT" to connect it to another device.
• Master-Slave-Mode:
To use the daisy chain / Master-Slave-Mode connect two (or more) laser projectors of the
same series via DMX cables:
Master projector (DMX out) -> DMX cable -> slave projector 1 (DMX in) ;
slave projector 1 (DMX out) -> DMX cable -> slave projector 2 ...etc.
Master projector
Select auto or music mode
at the master projector
(see above)
10. Turn device off
To turn off the device switch it off („OFF"), turn the key ‚OFF' and disconnect the power
cable from the mains.
Important Note:
Operate scanners/galvos only at appropriate speed according to the res-
pective scan angle. Too high scan speed will damage the scanning system.
page 9 / 30
Value
DMX cable
Function
Zoom
Blanking
Slave projector
To use this mode, please press the
MODE button until the display shows
SLAV and confirm by pressing DIR.