Hitachi C 10FCH Instructions De Sécurité Et Mode D'emploi page 11

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2. Releasing the locking pin
Handle
Pull
Locking Pin
Fig. 6
3. Installing the dust bag, holder, stopper and vises
(The holder and stopper are optional accessories.)
Attach the dust bag and vise assembly as indicated in Fig. 1 and Fig. 2.
BEFORE USING
1. Make sure the power source is appropriate for the tool.
WARNING:
Never connect the power tool unless the available AC power source is of the same
voltage as that specified on the nameplate of the tool.
Never connect this power tool to a DC power source.
2. Make sure the trigger switch is turned OFF.
WARNING:
If the power cord is connected to the power source with the trigger switch turned
ON the power tool will start suddenly and can cause a serious accident.
3. Check the saw blade for visible defects.
Confirm that the saw blade is free of cracks or other visible damage.
4. Confirm that the saw blade is attached securely to the power tool.
Using the supplied 10mm box wrench, tighten the bolt on the saw blade spindle to secure the saw
blade.
For details, see Fig. 33-a, Fig. 33-b, Fig. 33-c and Fig. 33-d in the section on "SAW BLADE MOUNTING
AND DISMOUNTING".
5. Check the lower guard for proper operation.
Fig. 7
WARNING:
NEVER OPERATE THE POWER TOOL if the safety cover does not function smoothly.
6. Confirm the position of the spindle lock before using the tool.
After installing the saw blade, confirm that the spindle lock has been returned to the retract position
before using the power tool (see Fig. 33-b).
When the power tool is prepared for shipping, its main parts are
secured by a locking pin.
Move the handle slightly so that the locking pin can be disengaged.
NOTE:
Lowering the handle slightly will enable you to disengage
the locking pin more easily and safely.
The lock position of the locking pin is for carrying and
storage only.
Lower guard is designed to protect the operator from coming into
contact with the saw blade during operation of the tool.
Always check that the lower guard moves smoothly and covers
the saw blade properly.
Lower Guard
English
11

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

C 10fce

Table des Matières