Replacing The Battery - Fujitsu LIFEBOOK S752 Guide D'utilisation

•
O
NCE THE LOW BATTERY NOTIFICATION MESSAGE APPEARS
S
LEEP MODE UNTIL YOU CAN PROVIDE A NEW POWER SOURCE
A /A
UTO
•
W
HEN YOU ARE IN
LIFEBOOK
Dead Battery Suspend mode shows on the Status indicator just like the normal Sleep mode. Once your notebook goes
into Dead Battery Suspend mode you will be unable to resume operation until you provide a source of power either
from an adapter or a charged battery. Once you have provided power, you will need to press the
Power/Suspend/Resume button to resume operation.
In the Dead Battery Suspend mode, your data can be maintained for some time, but if a power source is not provided
promptly, the Power indicator will stop flashing and go out, meaning that you have lost the data that was not stored.
Once you provide power, you can continue to use your notebook while an adapter is charging the battery.
Shorted Batteries
The Status Indicator panel uses a symbol inside the battery outline of the Battery Level indicator to display the
operating level available in that battery. If this display shows a Shorted Battery, it means the battery is damaged and
must be replaced so it does not damage other parts of your LIFEBOOK notebook.

Replacing the Battery

With the purchase of an additional battery, you can have a fully charged spare to swap with one that is not charged.
There are two ways to swap batteries, cold-swapping and hot-swapping:
Cold-swapping Batteries
To cold-swap batteries in your battery bay, follow these easy steps:
Have a charged battery ready to install.
1
Shut down your notebook and disconnect the AC adapter.
2
IRLINE ADAPTER AS SOON AS POSSIBLE
S
LEEP MODE THERE MUST ALWAYS BE AT LEAST ONE POWER SOURCE ACTIVE
S
NOTEBOOK IS IN LEEP MODE
,
YOU NEED TO SAVE ALL YOUR ACTIVE DATA AND PUT YOUR
. Y
OU SHOULD PROVIDE A CHARGED BATTERY
.
,
ANY DATA THAT HAS NOT BEEN SAVED TO THE HARD DRIVE WILL BE LOST
59
LIFEBOOK
, AC
AN POWER ADAPTER
. I
F YOU REMOVE ALL POWER SOURCES WHILE YOUR
.
NOTEBOOK INTO
,
OR