Expresscard Problems; Power Failures - Fujitsu LIFEBOOK S752 Guide D'utilisation

Problem
You installed a USB device, but
your notebook does not recog-
nize the device, or the device does
not seem to work properly.
(continued)

ExpressCard Problems

Installed ExpressCard does not
work or is locking up the system.

Power Failures

You turn on your LIFEBOOK note-
book and nothing seems to hap-
pen.
Possible Cause
The device may have been
installed while an application
was running.
Device may not have correct
software driver active.
The card is not properly
installed.
The card may have been
installed while an application
was running, so your note-
book is not aware of its
installation.
Correct software driver may
not be active.
You may have the wrong I/O
address selected for your card
device.
The primary battery is
installed but is faulty.
The battery or batteries are
low.
The power adapter (AC or
auto/airline) is not plugged
in properly.
Possible Solutions
Close the application and restart your notebook.
See your software documentation and activate the correct driver.
Remove and re-install the card. See "ExpressCards™/Smart Cards" on
page 70.
Close the application and restart your notebook.
See your software documentation and activate the correct driver.
See your ExpressCard documentation to determine the required I/O address.
Change the settings in the Device Manager.
Use the Status Indicator panel to verify the presence and condition of the batter-
ies. See "Status Indicator Panel" on page 22. If a battery is indicating a short,
remove that battery and operate from another power source or replace that bat-
tery.
Check the Status Indicator Panel to determine the presence and condition of the
batteries. See "Status Indicator Panel" on page 22. Use a Power adapter to
operate until a battery is charged or install a charged battery.
Verify that your adapter is connected correctly. See "Power Sources" on
page 43.
89