Replacing The Battery - Fujitsu LIFEBOOK S761 Guide D'utilisation

Replacing the Battery

With the purchase of an additional battery, you can have a fully charged spare to swap with one that is not
charged. There are two ways to swap batteries, cold-swapping and hot-swapping:
Cold-swapping Batteries
To cold-swap batteries in your battery bay follow these easy steps:
1
Have a charged battery ready to install.
2
Shut down your notebook and disconnect the AC adapter.
3
Orient your system as shown in Figure 26.
4
Push the spring-loaded battery latch away from the battery and hold it in place.
5
Push the battery lock to the right; this will unlock the battery.
6
Lift the battery out of the battery bay at the battery lift point (Figure 27) at the rear center of the battery.
7
Align a new battery into the bay, and press it down so that the latch clicks into place.
8
Push the right battery latch to the left.
9
Plug in the AC adapter and turn the power on.
Hot-swapping Batteries
To hot-swap batteries in your battery bay follow these easy steps:
B
E SURE TO PLUG IN AN
BATTERY PRESENT TO SUPPORT THE SYSTEM WHILE THE BATTERY IS BEING REPLACED
AC A
USE AN
1
Plug an AC Adapter into the system and connect it to a power outlet.
2
Follow steps 3 through 8 in "Cold Swapping Batteries".
I L
F THE ITHIUM ION BATTERY CONNECTOR IS NOT FULLY SEATED
NOTEBOOK OR CHARGE YOUR BATTERY
AC A
DAPTER PRIOR TO REMOVING THE BATTERY
DAPTER YOU WILL LOSE ANY UNSAVED FILES
.
65 - Lithium ion Battery
. T
HERE IS NO BRIDGE
.
,
YOU MAY NOT BE ABLE TO USE YOUR
. I
F YOU DO NOT