Hilti SID 14-A Mode D'emploi page 8

Power tool
Dimensions (L x W
x H)
Rated no-load run-
ning speed, pos. I
en
Rated no-load run-
ning speed, pos. II
Rated no-load run-
ning speed, pos. III
Impact speed
Speed adjustment
Standard screws
High-strength
screws
Chuck
Speed control
Forward / reverse
Deep discharge
protection
Power tool
Rated voltage
Weight (including
battery and chuck)
in accordance with
EPTA procedure
01/2003
Dimensions (L x W
x H)
Rated no-load run-
ning speed, pos. I
Rated no-load run-
ning speed, pos. II
Rated no-load run-
ning speed, pos. III
Impact speed
Speed adjustment
Standard screws
High-strength
screws
Chuck
Speed control
Forward / reverse
Deep discharge
protection
NOTE
The torque selector switch can be used to select three torque
settings.
Power tool
SID 14­A
SIW 14­A (³⁄₈"
square drive)
4
Printed: 30.09.2013 | Doc-Nr: PUB / 5155097 / 000 / 01
SID 14­A
151 mm x 81 mm x
228 mm
0...1,000/min
0...1,500/min
0...2,500/min
Max. 3,100/min
Three settings
M8 ­ M16
M6 ­ M12
¹/₄" hex. socket
with locking sleeve
Electronic, by way
of the control
switch
Electronic switch
with interlock to
prevent switching
while running
Yes
SID 22­A
21.6 V
1.5 kg
151 mm x 94 mm x
228 mm
0...1,000/min
0...1,500/min
0...2,500/min
Max. 3,450/min
Three settings
M8 ­ M16
M6 ­ M12
¹/₄" hex. socket
with locking sleeve
Electronic, by way
of the control
switch
Electronic switch
with interlock to
prevent switching
while running
Yes
Position I
50 Nm
65 Nm
SIW 14­A
154 mm x 81 mm x
228 mm
0...1,000/min
0...1,500/min
0...2,300/min
Max. 3,400/min
Three settings
M8 ­ M16
M6 ­ M12
¹/₂" square drive
with ball-notch
retention and ³/₈"
with locking ring
Electronic, by way
of the control
switch
Electronic switch
with interlock to
prevent switching
while running
SIW 22­A
21.6 V
1.5 kg
154 mm x 94 mm x
228 mm
0...1,000/min
0...1,500/min
0...2,300/min
Max. 3,500/min
Three settings
M8 ­ M16
M6 ­ M12
¹/₂" square drive
with ball-notch
retention and ³/₈"
with locking ring
Electronic, by way
of the control
switch
Electronic switch
with interlock to
prevent switching
while running
Yes
Position II
100 Nm
115 Nm
Position III
150 Nm
160 Nm