Maintenance - Husqvarna LB 146P, LB 246PI Manuel D'utilisation

Masquer les pouces Voir aussi pour LB 146P, LB 246PI:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 108
Do not cut more than ⅓ of the length of the grass.
Cut first with the cutting height set high. Examine the
result and lower the cutting height to an applicable
level. If the grass is very long, drive slowly and cut 2
times if necessary.
Introduction
WARNING: Before you do maintenance, you
must read and understand the safety
chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
Maintenance schedule
WARNING: When you tilt the product, make
sure that the air filter is up at the top of the
tilted product, and not against the ground.

Maintenance

Do a general inspection
Examine the oil level
Clean the product
Examine the cutting equipment
Examine the cutting cover*
Examine the engine brake handle*
Examine the battery*
Examine the muffler*
Examine the spark plug
Change the oil (the first time after 5 h use, then after each 50 h use)
Change the air filter (after 50 h use)
Examine the fuel system
To do a general inspection
Make sure that the nuts and screws on the product
are tightened.
To clean the product externally
Use a brush to remove leaves, grass and dirt.
Make sure that the air intake on the top of the engine
is not blocked.
10
Cut in different directions each time to prevent
stripes in the lawn.
Maintenance
The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with * see instructions in
Safety devices on the product on page 7 .
Do not use a high pressure washer to clean the
product.
If you use water to clean the product, do not flush
water directly on the engine.
To clean the inner surface of the cutting
cover
1. Empty the fuel tank.
2. Put the product on its side with the muffler down.
CAUTION: For model LB 246PI, always
remove the battery before you do
maintenance, repairs or clean the product.
Daily
Weekly
X
X
X
X
X
X
X
X
X
287 - 004 - 21.11.2017
Monthly
X
X
X

Publicité

Table des Matières
loading

Table des Matières