AERMEC FCZI P Série Manuel D'utilisation Et D'installation page 15

ALARM CODES
This section is reserved for the After Sales service only.
The card is located inside the unit and requires dismantling.
DANGER! Only qualified service personnel can access it.
There are 2 LEDs on the Inverter card (Alarm / Power) that indicate the
unit's operating status.
The table below shows how to decode the messages.
DIP SWITCHES
1 - 2 - 3 - 4
ALARM TYPE
High temperature
Overvoltage
Undervoltage
Overcurrent
Overload
Safety control
STOP
DIP SWITCH SETTING
In ducted installations, to allow adjusting the static pressure provided
by the fan coil to the pressure drops of the same duct, it is possible to
increase the maximum speed in the FCZI_P fan coils. To increase fan
speed, modify the settings of the dip switches located on the FCZI_P
motor.
Attention!: Follow the settings indicated in the table for each size of
FCZI_P.
0-10V CONTROL DEVICES (NOT INCLUDED)
Use a thermostat control and fan speed control with 0-10V outputs and
unit-compatible features. For installation, refer to the manuals of the
unit and accessory.
FCZI P 1712 - 4696555_03
FCZI
200 201 202 250
300 301 302 350
400 401 402 450
500 501 502 550
INDICATIONS
ALARM LED flashes
3sec ON 0.5sec OFF
The LED if permanently ON after
1.5min
ALARM LED flashes
0.5sec ON 0.5sec OFF
Alarm LED permanently on
IT EN
FCZI
700 900
701 901
702 902
750 950
IRREGULARITY
Motor off
Speed reduction
Motor off
FCZI2XXP
FCZI3XXP
FCZI4XXP
FCZI5XXP
FCZI7XXP
FCZI9XXP
FR DE ES
DIP SWITCHES
1 - 2 - 3 - 4
Notes
Auto-Restart Alarm.
If the conditions persist after
1.5min, the alarm becomes
permanent, the Alarm LED stays
on, the system turns off.
Power limitation
Temperature limitation
For alarms reset:
Set 0V ON INPUT
(turn the power off and then on
again)
15