Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3.
Remove the burner from the grill by lifting the burner out.
4.
Use a 6 mm socket and wrench or 6 mm nut driver to
remove the LP brass orifice from the end of gas valve.
The main burner NG orifice is located behind the LP orifice,
so no additional orifice needs to be installed.
A
A. Main burner orifice
IMPORTANT: Check that the LP orifice is properly removed
inside of the burner opening.
5.
Reinsert the burner and reattach using the cotter clips
previously removed. Repeat the procedure for each main
burner.
6.
Position the igniters so they are 1/8" (3.2 mm) away from
each burner.
Adjust High Flame Setting Screw
When converting from LP to Natural gas, you will need to adjust
the high flame setting screw for ideal burner flame height.
1.
Remove each control knob for the main burners and sear
burner.
2.
Use a flat-blade screwdriver to turn the high flame
setscrew counterclockwise approximate 90º.
26
Publicité
Table des Matières
