Replace The Driver Blade/Anvils - Josef Kihlberg a.560PN22 Mode D'emploi

KUDA PACKAGING
Fig. 11
SERVIS A NAHRADNÍ DÍLY
06.14
www.kuda-packaging.com

7.3 REPLACE THE DRIVER BLADE/ANVILS

– Disconnect tool from air supply.
– Remove six screws (Fig. 11/1) holding the rear
body to the front section.
– Remove the rear body (11/2) with magazine.
– Replace the driver blade (11/3).
– Assemble parts in reverse order.
2
If changing the anvils always change both at the same
time:
1
– Remove the driver blade (11/3).
– Remove the screw (11/4).
– Replace the anvils (11/5).
– Assemble parts in reverse order.
4
5
3
+420 607 237 237
Josef Kihlberg a.560PN22
info@kuda-packaging.com
servis@josef-kihlberg.eu
11