Operating Instructions - Danby DPAC8512 Guide D'utilisation Et Soins De Propriètaire

Operating Instructions

OPERATING
CONTROLS AND
MODES
COOL operation
- Press the "MODE" button until the "COOL" indicator light comes on.
- Press the ADJUST buttons "up arrow" or "down arrow" to select your
desired room temperature. The temperature can be set within a range of
17°C-30°C / 62°F-88°F.
- Press the "FAN SPEED" button to choose the fan speed.
HEAT operation (cooling only models without HEAT feature)
- Press the "MODE" button until the "HEAT" indicator light comes on.
- Press the ADJUST buttons "up arrow" or "down arrow" to select your
desired room temperature. The temperature can be set within a range of
17°C-30°C / 62°F-88°F.
- Press the "FAN SPEED" button to choose the fan speed. For some
models, the fan speed can not be adjusted under HEAT mode.
DRY operation
- Press the "MODE" button until the "DRY" indicator light comes on.
- Under this mode, you cannot select a fan speed or adjust the
temperature. The fan motor operates at LOW speed.
- Keep windows and doors closed for the best dehumidifying effect.
- Do not put the duct to window.
AUTO operation
- When you set the air conditioner in AUTO mode, it will automatically
select cooling, heating (cooling only models without HEAT feature) or fan
only operation depending on what temperature you have selected and the
room temperature.
- The air conditioner will control room temperature automatically round the
temperature point set by you.
- Under AUTO mode, you can not select the fan speed.
FAN operation
- Press the "MODE" button until the "FAN" indicator light comes on.
- Press the "FAN SPEED" button to choose the fan speed. The temperature
cannot be adjusted.
- Do not put the duct to window.
TIMER operation
- When the unit is on, first press the Timer button, the TIMER OFF indicator
light illuminates. It indicates the Auto Stop program is initiated.
- When the unit is off, first press the Timer button, the TIMER ON indicator
light illuminates. It indicates the Auto Start program is initiated.
- Press or hold the UP or DOWN button to change the Auto time by 0.5
hour increments, up to 10 hours, then at 1 hour increments up to 24
hours. The control will count down the time remaining until the unit starts.
- The selected time will register in 5 second and the system will
automatically revert back to display the previous temperature setting.
- Turning the unit ON or OFF at any time or adjusting the timer setting to
0.0 will cancel the Auto Start/Stop timed program.
- When the malfunction (E1 or E2) occurs, the Auto Start/Stop timed
program will also be cancelled.
SLEEP operation
Press this button, the selected temperature will increase (cooling) or
decrease (heating) by 1°C/2°F 30 minutes. The temperature will then
increase (cooling) or decrease (heating) by another 1°C/2°F after an
additional 30 minutes. This new temperature will be maintained for 7 hours
before it returns to the originally selected temperature. This ends the Sleep
mode and the unit will continue to operate as originally programmed.
NOTE: This feature is unavailabe under FAN or DRY mode.
8