Installation Instructions - Danby DPAC8512 Guide D'utilisation Et Soins De Propriètaire

Installation Instructions

LOCATION
WINDOW SLIDER KIT
INSTALLATION
• The air conditioner should be placed on a firm foundation to minimize
noise and vibration. For safe and secure positioning, place the unit on a
smooth, level floor strong enough to support the unit.
• The unit has casters to aid placement, but it should only be rolled on
smooth, flat surfaces. Use caution when rolling on carpet surfaces. Use
caution and protect floors when rolling over wood floors. Do not attempt
to roll the unit over objects.
• The unit must be placed within reach of a properly rated grounded
socket.
• Never place any obstacles around the air inlet or outlet of the unit.
• Allow at least 30cm of space from the wall for efficient air-conditioning.
Your window slider kit has been designed to fit most standard vertical and
horizontal window applications, However, it may be necessary for you to
improvise/modify some aspects of the installation procedures for certain
types of window. Please refer to Fig. 6& Fig.7 for minimum and maximum
window openings. Window slider kit can be fixed with a bolt (see Fig.8).
NOTE: If the window opening is less than the mentioned minimum length
of the window slider kit, cut the end without the whole in it short enough
to fit in the window opening. Never cut out the hole in window slider
kit. (visit www.danby.com for general instruction videos.)
Fig.5
Fig.7
Horizontal
Window
Window Slider Kit
Minimum:67.5cm(2.22ft).
Maxmum:123cm(4.04ft).
10
Fig.6
Horizontal
Window
Window Slider Kit
Minimum:67.5cm(2.22ft).
Maxmum:123cm(4.04ft).
Fig.8
Bolt
Window
slider
kit