Installation Instructions; Accessories; Required Tools - Danby DPA120DBAUGDB Manuel Du Propriétaire

INSTALLATION INSTRUCTIONS

ACCESSORIES

1. Air outlet adapter (x2)
2. Exhaust hose (x2)
3. Window slider adapter (x2)
4. 2 Bolts
5. Window slider A
6. Window slider B and C
7. Foam seal A (adhesive)
8. Foam seal B (adhesive)
9. Foam seal C (non-adhesive)
10. Security bracket and 2 screws
11. Drain hose
12. Remote control and batteries
1
2
3
4
5
6
7
8
9
10
11
12

REQUIRED TOOLS

1. Medium sized Phillips screwdriver
2. Tape measure or ruler
3. Knife or scissors
4. Saw (in the event that the window sliders need to
be cut to size)
ASSEMBLING THE WINDOW KIT
1. Attach the air outlet adapter and the window
slider adapter onto either end of the exhaust
hose. Do this for both exhaust hoses.
2. Insert the air outlet adapter into the lower
groove of the air outlet on the back of the
appliance. Ensure that the hook of the adapter
is aligned with the hole seat of the air outlet and
then slide down. Do this for both exhaust hoses.
3. Measure the window opening where the window
kit will be installed. Assemble as many sliders as
necessary to fi t the window.
4. If the length of the window requires all three
sliders, use two bolts to fasten the sliders at the
correct length.
5. If the window opening is less that the minimum
length of a single slider, use the slider that has
two holes in it and cut it to the correct length.
Make sure not to cut the end that has the holes
as this is necessary to attach the exhaust hose
adapters.
1
2
3
3