Service Menu - Cameo OPUS SP5 Manuel D'utilisation

Fan Fan control
DIMMER CURVES
linear
DMX value

SERVICE MENU

Starting from the main display, press ENTER to go to the main menu. Use the UP and DOWN control keys to select the Service menu and
press ENTER.
This will take you to the submenu for adjusting the submenu options (select via UP and DOWN, confirm via ENTER, change value via LEFT
and RIGHT, confirm via ENTER).
Calibrate - Calibrate the components with values of 000 to 255 (Password 050).
Test Manual - Manually test the components with values of 000 to 255.
Reset Motor - Reset the motors. All = All motors, Pan&Tilt = pan and tilt motors, Head Only = motors in device head.
USB Update - Firmware update via USB interface. OFF = Stop firmware update via USB interface. ON = Allow firmware update via USB
interface.
Factory Reset - Reset to factory settings.
DEVICE INFO (Info)
Starting from the main display, press ENTER to go to the main menu. Use the UP and DOWN control keys to select the Info menu and press ENTER.
This will take you to the submenu to view the device information (select via UP and DOWN, confirm with ENTER).
12
Head Fan
Base Fan
exponential logarithmic
DMX value
DMX value
Auto The fan speed will adjust automatically to the
temperature of the device head
Low Consistently low fan speed with reduced
brightness, as required
Auto The fan speed will adjust automatically to the
temperature of the device base
Low Consistently low fan speed with reduced
brightness, as required
S-curve
DMX value