Cameo OPUS SP5 Manuel D'utilisation page 6

3 FUSE
Fuse holder for 5 x 20 mm micro fuses. IMPORTANT INFO: Replace the fuse only with a fuse of the same type and values. If a fuse trips
repeatedly, please contact an authorized service center.
4 DMX IN
Male 3- and 5-pin XLR connector to connect a DMX control device (e.g. DMX console).
DMX OUT
5
Female 3- and 5-pin XLR connector to transmit the DMX control signal.
NET IN
6
RJ45 network connector to connect with an Art-Net or sACN network. When setting up the network, use cables of category CAT-5e or better.
7 NET OUT
RJ45 network connector to connect additional Art-Net-capable or sACN-capable devices with a network. When setting up the network, use
cables of category CAT-5e or better.
ANTENNA FOR W-DMX™
8
The antenna for W-DMX™ control remains in its holder during operation (= operating position).
11
PRESSURE-SENSITIVE LC-DISPLAY WITH BACKLIGHTING
9
Thanks to the pressure-sensitive LC display, the device can be operated directly from the display (can be used with gloves). The display
shows the currently active operating mode (main display), the menu options in the Options menu, and the numerical values or operating
status for certain menu options. If there is no control signal to the device, the display will begin to flash. This flashing will stop as soon as a
control signal is received (DMX and Slave mode, ArtNet and sACN).
TOUCH-SENSITIVE CONTROL FIELDS
10
MODE - Press MODE (repeatedly) to go one level higher in the menu structure to the main display.
UP  and DOWN  - Selects the individual menu options in the main menu (DMX address, operating mode, etc.) and in the submenus.
ENTER - Starting from the main display, press ENTER to go to the main menu. In the main menu, press ENTER to access the menu level
where you can change values. You can also confirm value adjustments by pressing ENTER.
LEFT  and RIGHT  - Use these buttons to change the value, for instance the DMX address, as desired.
6
9
10