Electrical Connection - ZANKER ZKC 9141 Notice D'utilisation

Mounting accessories included
2 screwdriver bits (for TORX screws).
1 deflector ,
1 reduction flange Ø 125-120 mm ,
1 chimney support,
5 wood-screws 5 x 45 mm (for wall mounting) ,
5 Wall dowels Ø 8 mm (for wall mounting) ,
2 washers
2 screws 3 x 9 (2 to fix the upper chimney)
1 metal screw 2,9 x13 (to fix the deflector).

Electrical connection

Safety warnings for the electrician
The mains power supply must correspond to the rating indicated on the plate situated inside the
hood. If provided with a plug connect the hood to a socket in compliance with current regulations
and positioned in an accessible area. If it not fitted with a plug (direct mains connection) or if the
plug is not located in an accessible area apply a bi-polar switch in accordance with standards which
assures the complete disconnection of the mains under conditions relating to over-current category
III, in accordance with installation instructions.
IMPORTANT: Before re-connecting the hood circuit to the mains supply and checking the efficient
function, always check that the mains cable is correctly assembled.
IMPORTANT! Power cable replacement must be undertaken by the authorized service assistance
centre or similar qualified person.
58