ZANKER ZKC 9141 Notice D'utilisation page 55

Charcoal filter
• The charcoal filter should only be used if you
want to use the hood in recirculation mode.
• To do this you will need an original charcoal
filter (available from your local Service Force
Centre).
• Replacing the charcoal filter
The charcoal filter cannot be washed nor
regenerated.
The charcoal filter should be replaced every
4 months under normal use.
Replacement filters are available from your
local Service Force Centre.
• Fitting:
R
Remove the grease filters.
Fit the charcoalfilters over the motor.
Align the pins R on the cowl with the slots
S, then turn the filter clockwise until it locks in
place.
Refit the grease filters.
• To remove proceed in the reverse order.
• Always specify the hood model code number
and serial number when ordering replacement
filters. This information is shown on the rating
plate located on the inside of the unit.
• The charcoal filter can be ordered from your
local Service Force Centre.
R
S
S
*
55