Layout; Items Supplied; Intended Use; Technical Data - EINHELL NEW GENERATION NBH 2000 H Mode D'emploi D'origine

Anleitung_NBH_2000_SPK7:_
GB
CAUTION
Read all the safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety information and instructions in a
safe place for future use.
2. Layout (Fig. 1/2)
1. Operating status indicator
2. Air outlet
3. Towel holders
4. Thermostat control
5. Heat output switch
3. Items supplied (Fig. 3)
Open the packaging and take out the equipment
with care.
Remove the packaging material and any
packaging and/or transportation braces (if
available).
Check to see if all items are supplied.
Inspect the equipment and accessories for
transport damage.
If possible, please keep the packaging until the
end of the guarantee period.
IMPORTANT
The equipment and packaging material are not
toys! Do not let children play with plastic bags,
foils or small parts! There is a danger of
swallowing or suffocating!
Bath heater (6)
Metal tubes (7)
Connecting part (8)
Assembly material (9)
Original operating instructions

4. Intended use

The equipment is designed for use as a wall-mounted
heater in the bathroom, WC, cellar, hobby room etc.
The equipment may be used only for its intended
purpose. Any other use is deemed to be a case of
misuse. The user/operator and not the manufacturer
will be liable for any damage or injuries of any kind
which result from such misuse.
12
18.05.2011 9:53 Uhr Seite 12
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
equipment is used in commercial, trade or industrial
businesses or for equivalent purposes.

5. Technical data:

Rated voltage:
Heat output:
Thermostat control:
Protection class:
Protection type:

6. Before starting the equipment

Note: With a towel holder fitted, the heat output is
automatically reduced to 1000 W.
6.1 Fitting the towel holder
(Fig. 4) Remove the two screws (E) from the
connecting part (8).
(Fig. 5) Push the two metal tubes (7) each into a tube
mount and secure them with the previously removed
screws (E).
(Fig. 6) Insert the connecting part (8) through the
guide on the rear of the bath heater housing until it
audibly clicks into position.
6.2 Wall-mounting
The equipment is allowed to be mounted only on a
wall. The minimum clearances must be observed.
The equipment is allowed to be used only when it is
completely assembled and in a vertical position.
Ensure that a minimum clearance of 40 cm to the
sides, 80 cm to the ceiling, 80 cm to the floor and 60
cm to the front of the housing are maintained.
Observe point 1 - Safety information.
Important! Make sure that there are no electric cables
or other installations (for example water pipes) near
the drill holes. Ensure that the equipment is secured
firmly and horizontally to the wall. Use only suitable
fastening material on a wall capable of bearing the
load. The supplied dowels and screws are suitable for
the following: concrete, natural stone with a dense
structure, solid brick, solid limestone bricks, solid
lightweight concrete bricks and aerated concrete.
When selecting the location for the equipment,
please note that if there are skirtings on the floor
220-240 V ~ 50 Hz
1800-2000 W
Infinitely adjustable
II
IP 21