Controls; Lighting - AEG DDE5980G Manuel De L'utilisateur

www.aeg.com
6

4. CONTROLS

A
Button Function
A
B
C
D
E
F
G
H
I

5. LIGHTING

• For replacement contact technical support
("To purchase contact technical support").
B C D
PANEL CLOSED
Brief pressure: Activates the keyboard functions.
The panel opens after 1 second, the lights turn
on at maximum intensity and the motor starts
at speed one (B).
PANEL OPEN
Brief pressure: Deactivates the keyboard func-
tions.
- When pressed for 3 sec., the panel closes.
MOTOR ON
Brief pressure: Motor off.
Activates speed one.
Activates speed two.
Activates speed three.
Activates INTENSIVE 1 speed for 10 minutes. At
the end of this time the system will automatically
return to the speed set before. It is disabled by
changing speed or pressing button A.
Press and hold the button for approximately 3 sec-
onds, with all the loads turned off (Motor and Lights),
to turn the Activated Charcoal Filter alarm on/off.
Activates INTENSIVE 2 speed for 5 minutes. At
the end of this time the system will automatically
return to the speed set before. It is disabled by
changing speed or pressing button A.
Activates BREEZE speed for 60 minutes. At the
end of this time the motor switches off. It is disabled
by changing speed or pressing button A.
Filter alarm button.
This button is normal off. It is only displayed
when the filter alarm is triggered. The alarm can
be reset by pressing and holding this button for
approximately 3 seconds.
Press briefly: Turns the lighting system on and off
at maximum intensity.
Press and hold to change the lighting intensity
up or down.
E F G
Led
The buttons turn white.
If the motor does not start the buttons switch
off after 1 minute.
All the buttons are on.
The button turns from white to red.
The button turns from white to red.
The button turns from white to red.
The button turns from white to red.
H flashes 5 times.
The button turns from white to red.
The button turns from white to red.
Button H fixed (30 seconds): indicates the need
to wash the metal grease filters. The alarm is
triggered after the Hood has been in operation
for 40 working hours.
Button H flashing (30 seconds): indicates the
need to change the activated charcoal filters,
and also to wash the metal grease filters. The
alarm is triggered after the Hood has been in
operation for 160 working hours.
-
-
H I I