Controls - AEG DGE5660HM Manuel D'utilisation

www.aeg.com
6

4. CONTROLS

L
Button Function
L
T1
T2
T3
T4
S1
T1
Turns the lights on/off at maximum strength.
Turns the motor on/off at speed one.
Turns the Motor on at speed two.
Press and hold the button for approximately 3 seconds, with
all the loads turned off (Motor and Lights), to turn the Activated
To turn the alarm off, press the button again and hold for at least
Turns the Motor on at speed three.
Press and hold the button for approximately 3 seconds, with all
the loads turned off (Motor and Lights), to perform a reset. The
Turns the Motor on at INTENSIVE Speed.
This speed is timed to run for 6 minutes. At the end of this time,
the system returns automatically to the speed that was set before.
If it is activated with the motor turned off, the hood will switch to
OFF at the end of the time.
Press and hold for 3 seconds to enable the remote control,
Press and hold for 3 seconds to disable the remote control,
Signals the Metal Grease Filter saturation alarm, indicating that it
Hood has been in operation for 100 working hours.
When this is activated, it signals the Activated Charcoal Filter
Metal Grease Filters must also be washed. The Activated Charcoal
Filter saturation alarm comes into operation after the Hood has
been working for 200 hours.
T2 T3
S1
T4
Led
-
Fixed.
Fixed.
-
Fixed.
-
Fixed.
-
Fixed.
Flashing.