Cleaning The Protection Hood; Cleaning / Changing The Air Filter - Makita DPC 6400 DPC 6401 Manuel D'instructions Et De Sécurité

Cleaning the protection hood

Over time, the inside of the protective hood can become caked
with material residue (especially from wet cutting), which if
allowed to accumulate can hinder the free rotation of the
cutting disc. For this reason the hood must be cleaned out
from time to time.
Take off the cutting wheel with spring washer and remove
the accumulated material from inside the hood with a strip of
wood or similar implement.
Clean the shaft and all disassembled parts with a cloth.

Cleaning / changing the air filter

STOP
Turn the cover lock (11) to the "Unlocked
carefully remove the filter cover (12).
There is an O-ring (G/15) between the filter cover (12) and
the air filter hood (G/14).
Unscrew the screws (13) and remove the air filter hood (14).
Clean the O-ring (15) with a brush and inspect for damage.
Remove the foam prefilter (17) from the filter cover.
Pull the paper cartridge (18) from the hood.
Remove the inner filter (16) from the intake opening.
Note:
Do not allow dirt to get into the carburetor!
Switch the combination switch to "Choke" or cover the
carburetor with a clean cloth.
NOTE: To install the cutting wheel see "Mounting the cutting
wheel".
11
12
" position and
16
17
STOP
14
13
15
18
E
F
G
H
19