Maintenance; First Aid - Makita DPC 6400 DPC 6401 Manuel D'instructions Et De Sécurité

Maintenance

- Before performing maintenance work switch off the Power
Cut (27) and pull out the plug cap.
- Always check the Power Cut before using it to make sure that
it is in good working order. In particular, make sure that the
cutting disc is properly mounted. Make sure that the cutting
wheel is undamaged and suitable for the job it will be used for.
- Operate the Power Cut only at a low noise and emission level.
For this ensure the carburetor is adjusted correctly.
- Clean the Power Cut regularly.
- Check the fuel tank cap regularly for good sealing.
Observe the accident prevention instructions issued by
trade associations and insurance companies. NEVER make
any modifications to the Power Cut! You will only be
putting your own safety at risk!
Perform only the maintenance and repair works described in
the instruction manual. All other work must be carried out by
MAKITA Service.
Use only original MAKITA spares and accessories.
The use of non-MAKITA spares, accessories, or cutting discs
increases the risk of accident. We cannot accept any respon-
sibility for accidents or damage occurring in association with
the use of cutting discs or accessories other than original
MAKITA.

First aid

For the event of a possible accident, please make sure that a
first aid kit is always immediately available close by. Immedi-
ately replace any items used from the first aid box.
When calling for help, give the following information:
- Place of the accident
- What happened
- Number of injured people
- Kind of injuries
- Your name!
NOTE
Individuals with poor circulation who are exposed to excessive
vibration may experience injury to blood vessels or the nervous
system.
Vibration may cause the following symptoms to occur in the
fingers, hands or wrists: "Falling asleep" (numbness), tingling,
pain, stabbing sensation, alteration of skin colour or of the skin.
If any of these symptoms occur, see a physician!
10
STOP
27
SERVICE
28
29