Putting Into Operation; Mounting The Cutting Disc - Makita DPC 6400 DPC 6401 Manuel D'instructions Et De Sécurité

STOP
A
1
B
5
7
C
10
2
D
12
2 3
Schematic drawing
7
5
8 9
8
1

PUTTING INTO OPERATION

CAUTION:
Always turn off the engine and pull off the spark plug cap
before doing any work on the Power Cut! Always wear
protective gloves!
CAUTION:
Start the Power Cut only after complete assembly and
inspection.
For the the following work, use the assembly tools included
with delivery:
1. 13/19 AF combination wrench
2. Allen key
3. Carburetor adjustment screwdriver
Place the Power Cut on a stable surface and carry out the
following assembly steps:

Mounting the cutting disc

Inspect the disc for damage.
See SAFETY INSTRUCTIONS, Page 6.
Unscrew screw (9) and remove the spring washer (8).
Place the cutting disc (5) on the arbour (7).
CAUTION:
When using a diamond cutting disc be sure to
mount it so that it rotates in the proper
direction!
Place the spring washer (8) on the arbour and insert the screw
(C/9) and tighten by hand.
Slowly turn the cutting disc until the stop hole of the V-belt
wheel is visible in the drive-arm hole (10).
Insert the Allen key (2) as far as it will go. The shaft is now
blocked.
Tighten the screw with the combination wrench (1)
NOTE: Tighten the screw firmly (30 ± 2 Nm), as otherwise the
cutting wheel may slip during cutting.