Electrolux EI24ID50Q Guide D'utilisation Et D'entretien page 8

8 Operating Instructions
S t a t u s w i n d o w
That STATUS window displays codes typically seen during normal operation or programming of the
dishwasher. The STATUS window indicates the following activity:
1h - 24h
CLOSE DOOR
Loc
U s e r I n s t r u c t i o n C o d e
Instruction
Code
Displayed
Close Door
E r r o r C o d e s
Displayed
Error Code*
i10
i20;
i40;
iF0
i30
i50
i60
iC0
*In all Error Code instances, if Pressing the cancel button or turning power off at the breaker for 5 min.
does not resolve the problem, contact the Electrolux Customer Care Center at 1-877-435-3287.
Indicates number of
delay start hours for
selected cycle.
Close door will scroll
across the status
window indicating
the door needs to
be closed.
Child Lock is activated.
Problem
This indicates the door has been
left open or not properly latched.
Problem
A low fi ll has been detected.
Clogged fi lters or a restricted
drain line has been detected.
A leak or overfl ow of water
has been detected in the
bottom pan.
A problem has been
detected with the drain or
wash motor.
A problem has been
detected with the water
heating system.
A problem has been
detected with the electronic
control system.
Minutes
L1 - L4
PRESS START Press start will scroll
Solution
Ensuring the door is properly latched will clear
the display. This does not indicate a problem with
your dishwasher and service will not need to be
contacted.
Solution
Look for a pinched water supply line, or water shutoff is
not completely opened.
Check and clean both fi lters and sump area and check
for a pinched or blocked drain hose. If the drain line is
attached to a disposer, check that the knockout plug
has been removed.
Look for loose connections at the water inlet valve and
ensure the unit is properly leveled.
Pressing the cancel button or turning power off at the
breaker for 5 min. should clear this error code and
the unit can be restarted.
If this does not resolve the problem, service
will need to be called.
The cycle duration or
the remaining time.
Level of Rinse Aid
Dosage.
across the status
window indicating the
START pad needs to
be pressed.