Replacement Parts - Remington 100271-01 Instructions D'utilisation

ELECTRIC CHAIN SAW
CLEANING AND
MAINTENANCE
Continued
Filing Cutter Depth Gauges
The cutter depth gauge clearance is reduced
as cutters are sharpened. After every second
or third sharpening, reset cutter depth gauges.
1. Place depth gauge tool firmly across top
of two cutters. Make sure depth gauge
enters slot in depth gauge tool (see Fig-
ure 22).
2. Use medium flat file. File depth gauge
level with depth gauge tool.
3. Remove depth gauge tool. With flat file,
round off front corner of cutter depth
gauge (see Figure 23).
After several hand filings, have authorized
service center or sharpening service machine
sharpen chain. This will insure even filing.
Depth
Gauge
Flat File
Depth
Gauge
Tool
Figure 22 - Depth Gauge Tool On Chain
Figure 23 - Round Off Front Corner Of
Depth Gauge
Replacing Saw Chain
Replace chain when cutters are too worn to
sharpen or when chain breaks. Only use
replacement chain noted in this manual. Al-
ways include new drive sprocket when re-
placing chain. This will maintain proper driv-
ing of chain. Note: For proper chain and
drive sprocket, see Replacement Parts.
RECYCLING
In the event it is not practical to repair your
chain saw, be sure to follow local and coun-
try codes for recycling plastic and metallic
materials when disposing of the unit.
STORAGE
If storing saw for more than 30 days, follow
steps below.
1. Drain oil tank.
2. Remove and clean guide bar and chain.
Clean guide bar and chain by soaking
in petroleum based solvent or mild soap
and water mixture.
3. Dry guide bar and chain.
4. Place chain in container filled with oil.
This will prevent rust.
5. Wipe a thin coating of oil over surface
of guide bar.
6. Wipe off outside of saw body. Do this
Depth
with soft cloth dampened with a mild
Gauge
Slot soap and water mixture.
7. Store chain saw
• in a high or locked place, out of
children's reach
• in a dry place
Front Corner
• in a carrying case or with scabbard
over guide bar
®
14
REPLACEMENT
PARTS
WARNING: Use only replace-
ment parts described in this
manual. Use of other parts could
damage saw or injure operator.
Purchase these parts from your local dealer.
Part Number Description
097570-01 Guide bar, 350 mm
091374-02S Chain, 350 mm
107713-01 Drive sprocket
102891