Panasonic CZ-RWSU2 Manuel D'utilisation page 20

11. Addresses (Cont.)
Setting Addresses (CZ-RWSY2/CZ-RWSK2)
(Setting the address of the indoor unit)
1. First of all, set the address for the remote control with Setting Remote Control Address
(See Page EN-14).
2. Press [Emergency Operation]
When you do this, the lamps of the display will blink one after another.
3. Press on the remote control.
4. The buzzer will sound and the address of the indoor unit will change to the address
displayed on the remote control.
5. If you press [Emergency Operation]
unit's display will turn off.
Note
• Please do not hold the [Emergency Operation]
display lamps are blinking one after another.
• Make sure to operate while the indoor unit is stopped.
• The address of indoor unit is set to "ALL" at the time of the shipment.
of the indoor unit for four seconds or more.
of the indoor unit once, the lamps on the indoor
button of the indoor unit down while the indoor unit's
EN-16