Before First Use; Daily Use - AEG LAVATHERM 65170AVM Notice D'utilisation

3. Press and hold buttons (A) and (D) at
the same time.
One of the these indicators comes on:
• End - the maximum dry laundry
• Cooling - the more dry laundry
• End and Cooling the standard dry
laundry
4. Press the button (E) again and again
until the indicator of the correct level
comes on.

9. BEFORE FIRST USE

Before you use the appliance for the first
time:
• Clean the tumble dryer drum with a
moist cloth.

10. DAILY USE

10.1 Start a programme
without delay start
1. Prepare the laundry and load the
appliance.
CAUTION!
Make sure that when you
close the door, the
laundry does not catch
between the appliance
door and the rubber
seal.
2. Set the correct programme and
options for the type of load.
3. Press the Start/Pause touchpad.
The programme starts.
10.2 Starting the programme
with delay start
1. Set the correct programme and
options for the type of load.
2. Press the delay start button again
and again as necessary.
You can delay the start
of a programme by 3, 6
or 9 hours.
3. Press the Start/Pause button.
The LEDs (9H, 6H, 3H) change on each 3
hours.
5. To confirm the adjustment, press and
hold buttons (A) and (D) at the same
time for approximately 2 seconds.
8.2 Buzzer permanent off
To deactivate or activate the acoustic
signals, press and hold for approximately
2 seconds touchpads (A) and (B) at the
same time.
• Start a short programme (e.g. 30
minutes) with moist laundry.
10.3 Change a programme
1. Turn the Programme knob to
2. Set the programme.
10.4 At the end of the
programme
When the programme is completed:
• An intermittent acoustic signal
operates (If the Buzzer function is on).
• The indicators End and Filter comes
on.
• The Start/Pause indicator is on.
The appliance continues to operate with
the crease guard phase for
approximately other 30 minutes.
The crease guard phase removes creases
from your laundry.
You can remove the laundry before the
crease guard phase is completed. We
recommend, for better results, that you
remove the laundry when the phase is
almost completed or completed.
When the crease guard phase is
completed:
• Start/Pause indicator goes off.
1. Turn the Programme knob to
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
ENGLISH 11
OFF
OFF