REX RX-401 E Manuel De L'utilisateur page 33

Assembly
Assembly
STEP 5
STEP 6
REX_Trainer_RX401E_13.indd GB-33 REX_Trainer_RX401E_13.indd GB-33
WARNING
1. Now assemble the left and the right pedal (20L +
20R) to the pedal arms (39L + 39R). During the as-
sembly, make sure that both pedals are installed on
the respectively correct side, otherwise they could
break out. The right pedal is screwed in clockwise and
the left pedal is screwed in anti-clockwise. For better
identifi cation, the pedals have been marked with an
"L" for left and an "R" for right. Tighten both pedals
fi rmly.
2. Fix the drink bottle holder (3) with two screws (4) to
the handlebar support tube (10) and insert the drink
bottle (93).
3. Now screw the backrest (25) to the seat clamp (7),
use four screws (86) for this.
4. Now connect the connector of the pulse cable (49) to
the socket of the cover (48).
5. Affi x four covers (96) to the screws (86).
WARNING
1. Connect the upper computer cable (41) and the cable
of the pulse sensors (46) to the display (8).
2. Fix the display with four screws (82) to the handlebar
support tube.
3. Set up the machine at the designated location.
4. Use the rear left and right height regulation to align
the home exercise machine so that it stands securely
and fi rmly.
5. Insert the plug of the mains adapter (50) into the
socket at the front left end of the home exercise ma-
chine (see Fig.).
6. Then insert the mains adapter into the power outlet.
The machine is ready to operate.
GB-33
06.05.13 09:41 06.05.13 09:41