Assembly - REX RX-401 E Manuel De L'utilisateur

Assembly

Assembly
STEP 1
STEP 2
REX_Trainer_RX401E_13.indd GB-31 REX_Trainer_RX401E_13.indd GB-31
WARNING
1. Place the front foot (2) and the rear foot (6) on the
fl oor as illustrated.
2. Mount both feet to the frame (1). Use four Allen
screws (30), four cap nuts (12), four spring clips (11)
with one washer (31) in each case.
WARNING
1. Push the seat clamp (7) onto the square tube (60) as
shown.
2. Align one hole of the seat clamp with the locking
screw. You can adjust the seat distance in twelve
different stages.
3. To adjust the seat distance, pull the knob of the lo-
cking screw away from the machine.
4. Make sure that the locking screw re-engages proper-
ly and tighten it fi rmly.
GB-31
06.05.13 09:41 06.05.13 09:41