REX RX-401 E Manuel De L'utilisateur page 32

Assembly
STEP 3
STEP 4
GB-32
REX_Trainer_RX401E_13.indd GB-32 REX_Trainer_RX401E_13.indd GB-32
WARNING
1. Mount the square tube (60) to the frame (1). Use two
screws (55) and two washers (66) for the rear side
(see Fig. A). To assemble the front side, use two
screws (56), two spring clips (11), two washers (66)
and two nuts (12) (see Fig. B).
2. Now push the cover (62) over the screw connection
(see Fig. C).
3. For the rear side, connect the rear pulse cable (48) to
the middle pulse cable (47) (see Fig. D).
4. Finally, push the rear cover (75) onto the frame (see
Fig. E).
WARNING
1. Connect the upper computer cable to the lower com-
puter cable (41 + 88) as well as the middle hand
pulse cable to the front hand pulse cable (46 + 47).
2. Push the handlebar support tube (10) on to the main
frame (1). Make sure not to pinch the computer cable.
3. Now fasten the handlebar support tube with four Al-
len screws (13) as well as one each (66) and one
spring clip (11) each to the frame.
4. Fasten the seat (18) with four washers (66) and four
screws (15).
5. Then mount the handle (5) with two screws (87) and
one washer (31) and one spring clip (11) each.
6. Affi x two covers (95) to the screws (87).
Assembly
06.05.13 09:41 06.05.13 09:41