Becker Centronic EasyControl EC142-II Notice De Montage Et D'utilisation page 32

• Switch off the power supply to the receiver for 5 seconds, then switch it back on
or
• Operate the programming button or the radio switch of the receiver.
The receiver is now in programming mode for 3 minutes.
b) Programming the master transmitter
Press the programming button on the master transmitter while in programming mode
until the receiver confirms that programming has been successful.
The programming process is now complete.
2) Programming additional transmitters
1. Press the programming button of the master transmitter until the receiver con-
firms.
2. Then press the programming button of the new transmitter until the receiver
confirms.
3. Now press the programming button of the new transmitter again.
4. The receiver confirms successful programming.
32 - en