Before Installing This Navigation Unit; Installation With The Holder And Side Bracket - Pioneer AVIC-F910BT Manuel D'installation

Section
04 Installation
Before installing this
navigation unit
% Remove the holder.
Loosen the screws (3 mm × 6 mm) to remove
the holder.
Installation with the holder
and side bracket
1 Install the holder into the dashboard.
After inserting the holder into the dashboard,
select and bend the tabs appropriate to the
thickness of the dashboard material. (Install
this navigation unit as firmly as possible using
the top and bottom tabs. To secure this naviga-
tion unit, bend the tabs 90 degrees.)
Holder
22
Engb
Holder
Screw (3 mm × 6 mm)
Dashboard
2 Install this navigation unit and fasten
the screws.
Dashboard
3 Attach the trim ring.
Trim ring
Screw (3 mm × 6 mm)