AEG FAVORIT 65060 VI1P Notice D'utilisation page 24

24 www.aeg.com
5.1 ExtraHygiene
With this function you have better hy-
giene results. During the rinsing phase,
the temperature stays at 70 °C for at
least 10 minutes.
How to activate the ExtraHygiene
option
1. Press ExtraHygiene. The related in-
dicator comes on. In the display you
can see the update of the pro-
gramme duration.
• If the option is not applicable to
the programme, the related indica-
tor flashes quickly 3 times and then
goes off.
5.2 TimeSaver
This option increases the pressure and
the temperature of the water. The wash-
ing and drying phases are shorter. The
total programme duration decreases by
approximately 50%.
The washing results are the same as with
the normal programme duration. The
drying results can decrease.
How to activate the TimeSaver option
1. Press TimeSaver. The related indica-
tor comes on. In the display you can
see the update of the programme
duration.
• If the option is not applicable to
the programme, the related indica-
tor flashes quickly 3 times and then
goes off.
5.3 Multitab
Activate this option only when you use
the combi detergent tablets.
This option deactivates the use of rinse
aid and salt. The related indicators stay
off.
The programme duration can increase.
How to activate the Multitab option
1. Press the on/off button to activate
the appliance.
2. Press Multitab, the related indicator
comes on.
The option stays on until you deactivate
it. Press Multitab, the related indicator
goes off.
If you stop to use the combi
detergent tablets, before you start to
use separately detergent, rinse aid
and dishwasher salt, do these steps:
1. Deactivate the Multitab option.
2. Set the water softener to the highest
level.
3. Make sure that the salt container and
the rinse aid dispenser are full.
4. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
5. Adjust the water softener to the wa-
ter hardness in your area.
6. Adjust the released quantity of rinse
aid.
5.4 Acoustic signals
The acoustic signals operate when the
appliance has a malfunction, when the
adjustment of the level of the water soft-
ener occurs and when the programme is
completed.
By default, the acoustic signals are on,
but it is possible to deactivate them.
How to deactivate the acoustic signals
1. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode.
2. Press and hold, at the same time,
Program and ExtraHygiene until the
indicators of Delay, Program and Ex-
traHygiene start to flash.
3. Press ExtraHygiene.
• The indicators of Delay and Pro-
gram go off.
• The indicator of ExtraHygiene con-
tinues to flash.
• The display shows the current set-
ting.
Acoustic signals on.
Acoustic signals off.
4. Press ExtraHygiene to change the
setting.
5. Press the on/off button to deactivate
the appliance and to confirm the set-
ting.