Publicité
Les langues disponibles
Les langues disponibles
4. Place the tool on the e-clip and apply pressure to free
the e-clip from the rail clamp tension bolt.
5. Unscrew the rail clamp tension bolt and remove it completely
(the tension spring must stay with the rail clamp tension bolt).
Flashlight Mounting/Removal
MAKE SURE THAT THE FIREARM IS UNLOADED AND THE BREECH IS OPEN. IT
IS IMPERATIVE THAT SAFETY MEASURES BE EMPLOYED AT ALL TIMES WHILE
HANDLING THE FIREARM.
1. The TLR-3
/TLR-4
®
or detached from the side of the weapon or accessory rail.
2. Loosen the rail clamp tension bolt.
3. Angle the TLR-3
the fixed portion of the rail clamp
against the accessory rail and align
the rail key with the appropriate
cross groove in the accessory rail.
4. Depress the rail clamp tension
bolt to open the rail clamp, rotate
the TLR-3
/TLR-4
®
release the pressure on the tension
bolt to "snap" the light in place.
5. Check for fit and tighten rail clamp tension bolt until the
TLR-3
/TLR-4
®
NOTE: A coin should be used to obtain sufficient tightness. Tighten only "finger tight".
Battery Installation/Removal
FOR SAFETY PURPOSES THE TLR-3
FIREARM BEFORE THE BATTERY COMPARTMENT IS OPENED OR CLOSED.
At the end of battery life, the switch may appear intermittent or
non-functional. Replacing the battery will restore normal operation.
• Unscrew and remove the facecap
assembly from the body of the
TLR-3
/TLR-4
®
™
the exhausted battery from the
flashlight body.
• Insert a fresh CR2 battery (positive
end first) into the body of the
TLR-3
/TLR-4
®
™
polarity is indicated on the side of
the TLR-3
/TLR-4
®
is designed to be quickly attached
™
/TLR-4
, placing
®
™
into place and
™
is securely attached to the firearm.
™
and remove
Note: Battery
body.
™
/TLR-4
MUST BE REMOVED FROM THE
®
™
Publicité
