Olympia PS 17 CD Mode D'emploi page 7

Clearing a jam
If too much paper is inserted in the cutting unit, it will cause a jam.
Proceed as follows:
Push the sliding switch to the Paper Rev /CD position.
-
The cutting unit runs backwards and pushes the excess paper back.
-
Reduce the quantity and slide the switch to Paper Auto / CD again. The cutting unit runs
-
forward again and the residue remaining is shredded.
If the backwards and forwards movement does not remedy the jam, pull out the mains plug
and remove the remaining manually from the cutting unit.
Motor protection
The motor switches off automatically in the event of overloading. Pull out the mains plug
from the socket and allow the motor to cool down to room temperature. Plug the mains
cable back in and then continue operation.
Notes on care and maintenance
Caution: maintenance work may only be performed when the mains plug is pulled out.
To ensure your shredder enjoys a long working life, we recommend to clear residual material
from the cutting units at regular intervals and apply special oil for paper shredders to the
cutting unit. This special oil is available from specialist dealers or directly from our service centre
in Hattingen. This will extend the service life of the device.
Technical data
Model:
Power supply:
Cutting width of the paper slot:
Cutting width of the CD slot: 120 mm, width of cut strips: approx. 30 mm
Cutting power:
Security level:
Max. power consumption:
Size (W x H x D):
Weight:
Operating cycle paper: 2 min. on, 15 min. off
Operating cycle CD: 2 min. on, 15 min. off
PS 17 CD
220-240 V / 50Hz
215 mm, width of cut strips: 7 mm
2
7 DIN A4 sheets (70 g/m ), 1 CD
1
0.5 A
300 x 185 x 320 mm
3.6 kg
Device malfunctions
Problem Cause
Device does not Is the mains cable plugged
work properly in the socket?
Is the sliding switch set to
Off?
Does the motor not start when
paper is inserted?
Device does not Was the device in constant
work after lengthy operation for some time?
operation or stops Is the surface of the device
during operation warm?
Jam Have you inserted more than
7 sheets of paper (70 g/m²) or
more than 1 CD?
Has the material not been
inserted straight in the in-feed
slot?
If you cannot rectify the fault yourself, contact your dealer or call the Olympia hotline.
Disposal Notes
This symbol [the crossed-out wheeled bin/PICTURE] means that the product should be
brought to the return and or separate collection systems available to end-users, when the
product has reached the end of its lifetime. This symbol applies only to the countries within
the EEA (*).
(*) EEA = European Economic Area, which comprises the EU Member States
plus Norway, Iceland, and Liechtenstein.
Remedy
Plug the mains cable into the socket
properly.
Set the sliding switch to Paper Auto
or Paper Rev / CD.
Slide the paper in the respective slot
so that it touches the sensor in the
centre.
Pull out the mains plug from the
socket and allow the motor to cool
down to room temperature.
Set the sliding switch to
Paper Rev / CD to push back the
paper. Switch the device to Paper
Auto again to shred the paper
remaining in the cutting unit.