Listening To A Cd - Teac MC-D800 Mode D'emploi

1 Press the CD/Bluetooth/USB button to
select "CD".
Z
Each time you press the CD/Bluetooth/USB button,
the function will change as shown below .
CD Bluetooth
After switching to CD, "DISC" will appear, "READING"
will blink for several seconds, and then the CD will
be in a stopped state . If no disc is loaded, "NO DISC"
appears on the display .
2
Press the open/close (- ) button to
open the tray.
Z
The disc tray opens forward .
30

Listening to a CD

3
o Never place more than one disc on the tray .
o If the tray is closed while a disc is outside the center
o Do not force the tray by hand when opening or
USB
4
Place a disc centered on the tray with
the labeled side up.
guides, the disc might become stuck inside and the
tray might not open . Be sure to always place discs
within the guides at the center of the tray .
closing .
Press the open/close (-) button to
close the tray.
Z
Be careful not to let your fingers be pinched when
the tray closes .
o The unit takes a few seconds to load the disc . No
buttons will work when "READING" is displayed .
Wait until the disc information is displayed .