Listening To A Cd - Teac LP-P1000 Mode D'emploi

1 Press the CD/Bluetooth button to select
CD.
Press the CD/Bluetooth button again to switch
between CD and Bluetooth.
After switching to CD, "DISC" will appear, "READING"
will blink for several seconds, and then the CD will
be in a stopped state. If no disc is loaded, "NO DISC"
appears on the display.
2 Press the open/close (-) button to
open the tray.
The disc tray opens forward.
30

Listening to a CD (1)

3 Place a disc centered on the tray with
the labeled side up.
o Never place more than one disc on the tray.
o If the tray is closed while a disc is outside the center
guides, the disc might become stuck inside and the
tray might not open. Be sure to always place discs
within the guides at the center of the tray.
o Do not force the tray by hand when opening or
closing.
4 Press the open/close (- ) button to
close the tray.
Be careful not to let your fingers be pinched when
the tray closes.
o The unit takes a few seconds to load the disc. No
buttons will work when "READING" is displayed.
Wait until the disc information is displayed.