Christopeit Sport Walker Notice De Montage Et D'utilisation page 14

Step 4:
Checks
1. Check the correct installation and function of all screwed and plug
connections. Installation is thereby complete.
2. When everything is in order, familiarize yourself with the machine at a
low resistance setting and make your individual adjustments.
Note:
Please keep the tool set and the instructions in a safe place as these may
be required for repairs or spare parts orders becoming necessary later.
For safety reason, please lock up the Walker when you don't use it with
locking pin (40). Therefore put the holes of connection tubes 2 (5L+5R) with
welded eye of main frame (1) into align position and push the locking pin
(40) trough all holes.
Fold up the Walker:
1. Screw out the hand grip screw (38), put the hand grips (6L+6R) into
lowest position and secure this position by using hand grip screws (38).
3. Turn out the hand grip screws (36+37) and put the both foot pedal
(7) In upper position, so that the holes of connection tubes 2 (5L+5R)
with welded eye of main frame (1) are align. Push the locking pin (40)
through all holes.
2. Pull out the safety pin (41), fold down the front foot (2) to rear side and
secure rear position by using safety pin (41) as picture „A" and „B"
shows.
4. To avoid Walker fall down, please storage the fold up Walker against a
wall or lay it flatly on the floor.
14