Philips Azur GC4400 Série Mode D'emploi page 16

EnGlish
16
Problem
The iron
does not
produce a
steam
boost.
Water
droplets
drip onto
the fabric
during
ironing.
4239.000.6215.6.indd 16
Possible cause
The iron is not hot
enough and/or the
drip-stop function
has been activated.
You have used the
steam boost
function too often
within a very short
period.
The iron is not hot
enough.
You have not closed
the cap of the filling
opening properly.
You have put an
additive in the
water tank.
The set
temperature is too
low for steam
ironing.
Solution
Set an ironing temperature that is
suitable for steam ironing ( 2 to
MAX). Put the iron on its heel
and wait until the temperature
light has gone out before you
start ironing.
Continue ironing in horizontal
position and wait a while before
you use the steam boost function
again.
Set an ironing temperature at
which the steam boost function
can be used ( 3 to MAX). Put
the iron on its heel and wait until
the temperature light has gone
out before you use the steam
boost function.
Press the cap until you hear a
click.
Rinse the water tank and do not
put any additive in the water tank.
Set a temperature of or 2
higher.
23-10-09 10:05