Daily Use - AEG FAVORIT 88072 I Notice D'utilisation

DAILY USE

1. Open the water tap.
2. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode, refer to 'SET-
TING AND STARTING A PRO-
GRAMME'.
• If the salt indicator is on, fill the salt
container.
USING THE DETERGENT
A
SETTING AND STARTING A
PROGRAMME
Setting mode
The appliance must be in setting mode to
accept some operations.
The appliance is in setting mode when,
after the activation:
• All the programme indicators come on.
• The display shows two horizontal status
bars.
If the control panel shows other condi-
tions, press and hold Delay and Start at
the same time until the appliance is in set-
ting mode.
Starting a programme without
delay start
1. Open the water tap.
2. Press the on/off button to activate the
appliance.
3. Close the appliance door.
4. Make sure that the appliance is in set-
ting mode.
B
30
A
20
+ -
C
• If the rinse aid indicator is on, fill the
rinse aid dispenser.
3. Load the baskets.
4. Add the detergent.
5. Set and start the correct programme
for the type of load and the degree of
soil.
1. Press the release button (B) to open
the lid (C).
2. Put the detergent in the compart-
ment (A) .
3.
If the programme has a prewash
phase, put a small quantity of deter-
gent on the inner part of the appli-
ance door.
4. If you use detergent tablets, put the
tablet in the compartment (A).
5. Close the lid. Make sure that the re-
lease button locks into position.
5. Press Program again and again until
the indicator of the programme that
you want to set comes on.
• The programme duration flashes in
the display.
• The phase indicators of the set pro-
gramme come on.
6. If you want, you can set the options.
7. Press Start. The programme starts.
• Only the indicator of the phase in
operation stays on.
• The display shows the programme
duration that decreases with steps
of 1 minute.
Starting a programme with
delay start
1. Set the programme and the options.
2. Press Delay again and again until the
display shows the delay time you want
to set (from 1 to 24 hours).
• The delay time flashes in the dis-
play.
• The delay indicator is on.
3. Press Start. The countdown starts.
ENGLISH
31