Connections; Connecting The Suction Hose; Electrical Connection; Connecting Power Tools - Makita 447 L Notice D'utilisation

MAKITA 447 L
english
4 Operation
4.1

Connections

4.1.1 Connecting the suction
hose

4.1.2 Electrical connection

4.1.3 Connecting power
tools
4.2 Switching on the
vacuum cleaner

4.2.1 Switch position "I"

4.2.2 Switch position "auto"

6
The operating voltage shown
on the rating plate must corres-
pond to the voltage of the
mains power supply.
To comply with regulations, only
approved dust producing tools
should be connected.
The maximum power consump-
tion of the connected power tool
is stated in section 9.4 "Techni-
cal data".
CAUTION!
Before switching the switch
to position "auto", ensure
that the power tool connect-
ed to the appliance socket is
switched off.
1. Connect the suction hose.
1. Ensure that the cleaner is
switched off.
2. Insert the power cord into a
properly installed and fused
socket with earthing contact.
1. Ensure that the power tool
is switched off.
2. Connect the power tool to
the appliance socket on the
control panel.
1. Turn the switch to position
"I".
The vacuum cleaner motor
starts.
1. Turn the switch to position
"auto".
The vacuum cleaner motor
starts when the connected
power tool is switched on.
2. When the power tool is
switched off, the vacuum
cleaner continues to run for
a short moment so that any
dust in the suction hose is
conveyed to the filter bag.