Mounting The Flat Screen - Goobay TV EasyFold Slim XL2 Mode D'emploi

User Manual
Fig. 10: Aligning and marking
Fig. 11: Drilling holes
Fig. 12: Wall mounting
4.3 Mounting the flat screen
Tab. 18: Mounting the flat screen
22
Risk of injury by tripping and falling
>> Place, transport and install product, parts
and acceories in a safe way.
Risk of material damage by improper
procedure
>> Only use moderate force when tightening
the screws in order to avoid damaging
threads.
>> NEVER set the screen on the front during
installation!
>> Do not damage the flat screen by too
long screws.
1. R emove the plastic covers.
2. Before drilling, attend to live
cables or other lines lying
b ehind plaster, and do not
damage them.
3. Use a spirit level to mark the
drill holes on the wall.
4. Mark the drill holes 1 to 6 with
a pencil.
Use the TV wall mount (A) as
template.
5. D rill the drill holes with a
10 mm concrete drill 60 mm
deep.
6. Plug a concrete anchor (W-B)
in each drilling hole.
7. F irst, screw the middle, upper
screw so that it protrudes
approximately 5 mm.
8. A lign the TV wall bracket (A).
9. F asten the TV wall bracket (A)
with the remaining wall screws
(W-A) and washers (W-C).