Makita XRH01 Manuel D'instruction page 8

If the bit cannot be pushed in, remove the bit. Pull the
chuck cover down a couple of times. Then insert the bit
again. Turn the bit and push it in until it engages.
After installing, always make sure that the bit is securely
held in place by trying to pull it out.
To remove the bit, pull the chuck cover down all the way
and pull the bit out.
2
1
012625
Bit angle
(when chipping, scaling or demolishing)
012632
The bit can be secured at the desired angle. To change
the bit angle, depress the lock button and rotate the
action mode changing knob to the O symbol. Turn the bit
to the desired angle.
Depress the lock button and rotate the action mode
changing knob to the
bit is securely held in place by turning it slightly.
012633
1. Bit
2. Chuck cover
1. Action mode
changing knob
2. O symbol
2
1
symbol. Then make sure that the
Depth gauge
1
3
2
012626
The depth gauge is convenient for drilling holes of
uniform depth. Loosen the side grip and insert the depth
gauge into the hole in the side grip. Adjust the depth
gauge to the desired depth and tighten the side grip.
NOTE:
The depth gauge cannot be used at the position where
•
the depth gauge strikes against the gear housing.
Dust cup
012636
Use the dust cup to prevent dust from falling over the tool and
on yourself when performing overhead drilling operations.
Attach the dust cup to the bit as shown in the figure. The size
of bits which the dust cup can be attached to is as follows.
Dust cup 5
Dust cup 9
006386
OPERATION
Hammer drilling operation
012634
Set the action mode changing knob to the
Position the bit at the desired location for the hole, then
pull the switch trigger.
8
1. Hole
2. Depth gauge
3. Loosen
4. Tighten
4
1. Dust cup
1
Bit diameter
6 mm (1/4") - 14.5 mm (9/16")
12 mm (15/32") - 16 mm (5/8")
symbol.