Pioneer PDP-5080HD Mode D'emploi page 23

Preparation
Attaching the stand again
• When the plasma display is mounted without the supplied
speaker, begin with step 2 (for PDP-5080HD).
• Begin with step 2 for PDP-4280HD.
• Besides the speaker, steps for attaching the stand are the
same for PDP-5080HD and PDP-4280HD (use the screw
holes with "T" inscribed). Illustrations shown are for
PDP-5080HD.
1
Detach the supplied speaker when the plasma display is
being mounted on the wall, with the speaker attached.
• To detach the speaker, remove the cable wiring for the
speaker at the rear and screws at the bottom of the
speaker and pull it out (see illustrations on page 20).
2
With the plasma display lying flat, fit the stand's
support columns to the bottom of the plasma display as
indicated by the arrows, then slowly insert them.
• Be extremely careful not to insert the support columns of
the stand into any part of the plasma display other than the
stand insertion slots. Doing so might damage the plasma
display panel or its ports or result in warping of the stand.
Plasma
display
Insert the stand into the plasma
display so that an arrow with
"FRONT/FACE AVANT" mark
inscribed at the bottom of the
stand indicates downward.
Line up the column supports
with the bottom of the plasma
display, as indicated in the
accompanying diagram.
Sheet
3
Attach the stand at the points indicated by the arrows
and tighten the installation bolts (2) and (1) firmly using
a screwdriver.
Installation bolts (1): M8 x 23 mm (black) for PDP-4280HD
M8 x 23 mm (black) for PDP-5080HD
Installation bolts (2): M8 x 60 mm (black) for PDP-4280HD
M8 x 40 mm (black) for PDP-5080HD
Screw hole with "T" inscribed
4
Replace the plasma display to stand upright.
For speaker installation, see "Installing the Pioneer
speaker" on page 16 (PDP-5080HD only).
Note
• Be sure to install the plasma display in a flat, stable location.
• Insert the screws into the holes vertically and tighten them.
• Place a sheet or protective cover to protect the display from
scratches or damage.
• Work only with the plasma display lying flat on a table or similar
surface.
• When lying the plasma display down, be careful not to scratch
or damage it.
Installation bolts (1) (Step 2)
Installation bolts (2) (Step 1)
05
23
En