RCF L-PAD 10C Manuel Utilisateur page 7

FUNCTIONS
HOW TO GET SOUND FROM A RCF mixing consoles MIXER
1. Turn your RCF mixing consoles mixer on.
2. Set all the faders and controls to minimum position (0 or ‑∞)
3. Plug a microphone into the XLR connector ‑ MIC input of channel 1.
4. This adjusts GAIN according to microphone sensibility.
5. Connect your speaker system to the MAIN MIX output and turn it on.
6. Adjust the FADER up to "0" position.
7. Carefully turn up the MAIN MIX fader to reach a reasonable sound level.
8. Enjoy the quality of your RCF mixing consoles mixer.
HOW TO IMPROVE THE SOUND
The RCF mixing consoles mixer implements several powerful tools to improve the sound
quality of your music even more.
COMP: Turn the COMP control clockwise to add a compression effect to the signal.
This allows to control the dynamic of the signal, limiting peaks and gaining level in case
of low signals.
EQ: A three‑band EQ is available on each mono channel, while a dual‑band
EQ is available on stereo channels 7‑8 and 9‑10. Adjust these parameters to
subtract noise frequencies or magnify desired sounds.
AVAILABLE ACCESSORIES
- RCF mixing consoles PLAYER Card: USB stick based MP3 Player Card – Up to 32 GB capacity (p.n. 133 60 287)
- RCF mixing consoles recorder card: USB flash drive based MP3 player/recorder card ‑ Max. capacity: 32 GB (p.n. 133 60 288)
- RCF mixing consoles Bluetooth card: Bluetooth connection card. This card allows to play your music playlist from Smartphone, Tablet or any Bluetooth
device. (p.n. 133 60 289)
MOUNT ACCESSORIES
- MIC stand mount accessory (RCF Part Number: 133 60 290)
- Rack ears (RCF Part Number: 133 60 291)
7