Imetec NUVOLA L5801 Mode D'emploi page 13

• The iron must be used on a stable surface. When the iron is placed
on the iron rest, make sure the support is stable. The iron must not
be used if it has been dropped, if it is visibly damaged or if it leaks
water.
• If the power cable is damaged it must be replaced by an authorised
technical service centre, so as to prevent all risks.
• The electrical safety of this appliance is only guaranteed when it
is connected correctly to an effective earthing system as required
by applicable electrical safety standards. This important safety
requirement must be verified and, if in doubt, request a thorough
check of the system by a qualified technician.
• The electrical safety of this appliance is only guaranteed when it
is connected correctly to an effective earthing system as required
by applicable electrical safety standards. This important safety
requirement must be verified and, if in doubt, request a thorough
check of the system by a qualified technician.
DO NOT immerse the iron, the power cord or the plug in any
kind of liquid.
DO NOT leave the hot iron in contact with easily flammable
fabric.
DO NOT leave the iron unattended when connected to the
power supply.
DO NOT dispense steam when the iron is resting on its mat.
ATTENTION! Hot surface.
DO NOT use chemical additives, scented substances or
descaling agents.
• This appliance was not manufactured to be used regularly.
• Before inserting the plug into the socket, make sure that the voltage
on the selector located under the heel corresponds to the voltage
of the local mains. To change the voltage, adjust the selector, using
a small screwdriver or a similar tool.
EN
11