Setting Up And Making A Aluminum Weld - Lincoln Electric 11937 Mode D'emploi

B-11
SETTING UP AND MAKING A ALUMINUM WELD USING SPOOL GUN
1. Loosen the THUMB SCREW Disconnect Magnum
100L Gun.
2. Insert K2532-1 Magnum 100SG spool gun into the
brass block and tighten the THUMB SCREW.
3. Depress Gun selector SWITCH to Spool Gun posi-
tion. (See Figure B.20 and B.21)
4. Connect a bottle of 100% Argon shielding Gas per
previous section.
5. Follow the MIG welding steps in the previous sec-
tion.
FIGURE B.20
6. Turn machine on and make weld per recommended
settings on Procedure Decal inside machine door.
The settings listed on the procedure decal are sug-
gestions. The dials may need to be adjusted to
accommodate the application, input voltage or user
preference.
OPERATION
(Location of Selector Switch and Thumb Screw)
THUMB SCREW FOR
CONNECTING THE
MAGNUM 100L GUN OR
MAGNUM 100SG SPOOL GUN.
WIRE FEEDER WELDER (180 MODEL)
FIGURE B.21
SWITCH
B-11
MAGNUM 100SG MAGNUM 100L